🔧 Front Turn Signal Bulbs - Bulb Replacement

Replace the front turn signal bulbs if they are dim, flashing quickly, or out completely. On some versions of your Equinox, the front signal is a replaceable bulb in the headlamp assembly; on LED-equipped versions, the lamp may be serviced as an assembly instead.

Difficulty Level: Beginner | Estimated Time: 0.5-1 hour

---

⚠️ Safety & Precautions

• Turn the lighting switch off and let the bulbs cool before touching the headlamp area.
• Do not touch the glass of a halogen bulb with bare fingers. Oil from skin can shorten bulb life.
• If your Equinox has LED front signal lamps, the bulb may not be replaceable. In that case, the headlamp assembly or LED module needs service.
• No battery disconnect is normally required for this repair.

---

🔧 Required Tools

You'll need the following tools for this repair:

• 7mm socket
• Ratchet
• Trim panel tool
• Flashlight
• Safety glasses
• Gloves

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Front turn signal bulbs - Replace in pairs - Qty: 2

---

📋 Before You Begin

• Park on level ground and set the parking brake.
• Turn the headlight switch off and remove the key/fob from the vehicle.
• Open the hood and make sure the headlamp area is cool.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Access the headlamp area

• Open the hood and locate the rear of the headlamp assembly on the side you are servicing.
• If access is tight, use the 7mm socket and ratchet to remove any upper air deflector or cover fasteners in the way.
• Keep the fasteners in order.

Step 2: Remove the bulb socket

• Reach behind the headlamp and twist the turn signal bulb socket counterclockwise by hand, or use a trim panel tool gently if needed for tight access.
• Pull the socket straight out of the housing.

Step 3: Replace the bulb

• Twist the old bulb out of the socket.
• Install the new bulb into the socket by hand.
• Do not touch the glass part of the bulb.

Step 4: Reinstall the socket

• Insert the socket back into the headlamp housing.
• Twist it clockwise until it locks in place.
• If you removed any covers or deflectors, reinstall them with the 7mm socket and ratchet.

Step 5: Test the turn signal

• Turn the ignition on.
• Activate the left and right turn signals.
• Make sure the new bulb flashes normally and the dash indicator is not flashing rapidly.

---

✅ After Repair

• Check both front signals from outside the vehicle.
• Confirm the lens is fully seated and no warning message appears.
• If the new bulb still does not work, the socket or wiring may need inspection.

---

💰 DIY vs Shop Cost

Shop Cost: $80-$180 (parts + labor)

DIY Cost: $10-$30 (parts only)

You Save: $70-$150 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.5-1 hour.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.