🔧 Grand Cherokee - Engine Air Filter Replacement

Your air filter keeps dust and debris out of your engine. Replacing it helps maintain smooth acceleration, good fuel economy, and protects the engine from wear.

Difficulty Level: Beginner | Estimated Time: 10-20 minutes

---

⚠️ Safety & Precautions

• ⚠️ Turn the engine off and let it cool 10 minutes before working near the intake.
• ⚠️ Keep fingers clear of the engine cooling fan area.
• ⚠️ Don’t run the engine with the air filter removed.
• ⚠️ Battery disconnect is not required for this job.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Safety glasses
• Nitrile gloves
• Flathead screwdriver
• Shop towel
• Flashlight

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Engine air filter - Qty: 1

---

📋 Before You Begin

• Park on level ground and shift to Park.
• Open the hood and locate the air filter box (the black plastic box connected to the large intake tube).
• Have a shop towel ready so you can wipe dust from the airbox lip.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Locate the air filter housing

• Use a flashlight to find the air filter box on the engine bay, attached to the intake tube.

Step 2: Open the air filter box

• Release the metal retaining clips around the airbox lid by hand.
• If a clip is stubborn, gently pry it with a flathead screwdriver (don’t snap the clip).
• Lift the lid just enough to remove the filter. Don’t force the intake tube.

Step 3: Remove the old air filter

• Lift the filter straight out of the airbox.
• Use a shop towel to wipe the sealing surface (the rim where the filter sits).
• Do not let dirt fall into the lower airbox. Wipe, don’t blow dirt inward.

Step 4: Install the new air filter

• Place the new filter into the lower airbox, making sure it sits flat and fully in its groove.
• Check that the rubber edge (seal) is evenly seated all the way around.

Step 5: Close and secure the airbox

• Lower the airbox lid into place.
• Re-latch all the retaining clips by hand.
• Do a quick visual check that the lid is evenly closed on all sides (no gaps).

---

✅ After Repair

• Start the engine and let it idle for 20–30 seconds.
• Listen for any whistling/hissing (that can mean the airbox lid isn’t fully clipped).
• Take a short drive and confirm normal throttle response.

---

💰 DIY vs Shop Cost

Shop Cost: $40-$90 (parts + labor)

DIY Cost: $15-$35 (parts only)

You Save: $25-$55 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.4 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.