🔧 Rear Turn Signal Bulb - Replacement

Replacing the rear turn signal bulb on your Camry is a straightforward job. You’ll access the bulb from inside the trunk by removing the tail lamp access covers, then twist out the bulb socket and install the new bulb.

Difficulty Level: Beginner | Estimated Time: 0.5-1 hour

---

⚠️ Safety & Precautions

• Turn the lights off and remove the key before starting.
• Let the tail lamp cool down if it has been on recently.
• Handle the new bulb with clean gloves or a clean cloth. Finger oils can shorten bulb life.
• Do not touch hot bulb glass with bare hands.
• No battery disconnect is required for this repair.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Trim panel tool
• Small flat-blade screwdriver
• Gloves
• Safety glasses
• Flashlight

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Rear turn signal bulb - Qty: 2

---

📋 Before You Begin

• Park on a level surface and set the parking brake.
• Open the trunk for access to the rear lamp housings.
• If one side is out, it is smart to replace both rear turn signal bulbs at the same time.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Open the trunk and clear access

• Open the trunk fully and move any cargo away from the left and right rear lamp areas.
• Use a flashlight to locate the access covers behind each tail lamp.

Step 2: Remove the tail lamp access cover

• Use a trim panel tool or small flat-blade screwdriver to gently pop off the rear lamp access cover inside the trunk.
• Work slowly so you do not crack the plastic cover.
• Practical tip: Pry at the edge, not the center.

Step 3: Remove the bulb socket

• Reach into the opening and find the rear turn signal bulb socket.
• Twist the socket counterclockwise by hand to unlock it, then pull it straight out.
• If it is stuck, use a gloved hand for better grip.

Step 4: Replace the bulb

• Pull the old bulb straight out of the socket.
• Install the new rear turn signal bulb by pushing it straight into the socket until fully seated.
• Make sure the bulb is fully locked in place before reinstalling it.
• Do not twist the bulb glass.

Step 5: Reinstall the socket

• Align the socket with the housing opening.
• Push it in fully, then twist it clockwise by hand until it locks.
• It should feel snug and seated evenly.

Step 6: Test the new bulb

• Turn the ignition on and activate the turn signal for the side you repaired.
• Check that the rear signal flashes normally.
• If it does not work, remove the socket again and confirm the bulb is seated correctly.

Step 7: Reinstall the access cover

• Snap the rear lamp access cover back into place by hand.
• Make sure it sits flush so cargo does not catch it.

---

✅ After Repair

• Check both rear turn signals, brake lights, and tail lights.
• Verify the instrument cluster does not show a bulb-out warning.
• If the lamp still does not work, inspect the socket for corrosion or a bent terminal.

---

💰 DIY vs Shop Cost

Shop Cost: $80-$150 (parts + labor)

DIY Cost: $10-$30 (parts only)

You Save: $70-$120 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.5-1 hour.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.