🔧 Front Wiper Blades - Replacement

The front windshield wiper blades on your Rogue are a simple DIY replacement. You’ll remove the old blades from the wiper arms and snap the new ones into place. This is a quick job, and fresh blades will restore wipe quality and help with rain visibility.

Difficulty Level: Beginner | Estimated Time: 0.5-1 hours

---

⚠️ Safety & Precautions

• Turn the ignition off and keep the wipers switched off before lifting the arms.
• Be careful not to let a bare wiper arm snap back onto the glass.
• Work with the arms lifted one at a time to avoid scratching the windshield.
• No battery disconnect is required.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Safety glasses
• Gloves

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Front wiper blades - Driver: 26", Passenger: 17" - Qty: 2

---

📋 Before You Begin

• Park on level ground with the ignition off.
• Lift one wiper arm at a time so the blade is easy to reach.
• Set the new blades next to the old ones so you can match the length and connector style.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Lift the wiper arm

• Use your hand to gently lift the driver-side wiper arm away from the windshield.
• Keep a firm grip so the arm does not snap back.
• Place a towel on the glass for protection.

Step 2: Remove the old blade

• At the center connector, press the release tab on the wiper blade.
• Slide the blade downward and off the hook on the arm.
• If it sticks, wiggle it slightly while holding the arm steady.

Step 3: Install the new blade

• Use the correct replacement blade for that side.
• Slide the new blade onto the hook until it clicks into place.
• Pull lightly on the blade to make sure it is locked.

Step 4: Repeat on the passenger side

• Lift the passenger-side wiper arm.
• Use the same release-and-slide method to remove the old blade.
• Install the new passenger-side blade and confirm it locks securely.

Step 5: Lower the arms carefully

• Gently lower both wiper arms back onto the windshield.
• Make sure they sit flat and do not hit the glass hard.

---

✅ After Repair

• Turn the ignition on and run the wipers with washer fluid.
• Check that both blades sweep smoothly and do not chatter or streak.
• If one blade does not sit flat, remove it and reinstall it until it locks correctly.

---

💰 DIY vs Shop Cost

Shop Cost: $60-$120 (parts + labor)

DIY Cost: $20-$45 (parts only)

You Save: $40-$75 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.5-1 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.