🔧 Tiguan - Engine Mount Replacement

Engine mounts support the engine/transmission and control vibration. On your Tiguan, there are multiple mounts (right/passenger-side engine mount, left/driver-side transmission mount, and the lower “pendulum/dogbone” mount), and the steps/torque specs vary by which one(s) you’re replacing.

Difficulty Level: Intermediate | Estimated Time: 1.5-4.0 hours

---

⚠️ Safety & Precautions

• 🛑 Never work under a vehicle supported only by a jack—always use jack stands.
• 🛑 The engine must be supported before loosening mount bolts, or it can drop and damage hoses/wiring.
• 🛑 Keep hands clear between the mount and bracket while lifting/supporting the engine.
• 🛑 Work on a cool engine—turbo/heat shields can burn you.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Floor jack (rated 3-ton minimum)
• Jack stands (rated 3-ton minimum)
• Wheel chocks
• Safety glasses
• Mechanic gloves
• Socket set (8mm-21mm)
• Ratchet
• Breaker bar
• Torque wrench (10-200 Nm range)
• Torx bit set (T25-T45)
• Triple-square bit set (M10-M14)
• Extensions (3" and 6")
• Pry bar
• Trim clip remover
• Wood block (2x4)
• Engine support bar (specialty)

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Engine mount (right/passenger-side) - Qty: 1
• Transmission mount (left/driver-side) - Qty: 1
• Lower pendulum/dogbone mount - Qty: 1
• Engine mount stretch bolt kit - Qty: 1

---

📋 Before You Begin

• 🧭 Park on level ground, set the parking brake, and chock the rear wheels.
• 🔧 Plan how you’ll support the engine: an engine support bar spans the fenders and holds the engine from above (safest for mounts). A floor jack with a wood block can support from below for some mounts.
• ❓ Which mount are you replacing: right engine mount, left transmission mount, or lower dogbone mount (or all)?
• ❓ Do you have an engine support bar, or will you be using a floor jack + wood block to support the engine?

---

🔨 Step-by-Step Instructions

Follow these steps in order:

I can give you the exact removal order and the correct VW torque specs once you answer the 2 questions above (mount location + how you’ll support the engine). The fastener types and torque values differ by mount, and your Tiguan uses one-time-use “stretch” bolts in several spots.

---

✅ After Repair

• 🔎 Start the engine and check for abnormal vibration or clunks at idle and on light throttle.
• 🔎 Recheck that nothing is contacting the exhaust/heat shields and that wiring/hoses aren’t stretched.
• 🔎 Do a short test drive, then re-inspect for any shifted alignment or loose fasteners.

---

💰 DIY vs Shop Cost

Shop Cost: $450-$1,400 (parts + labor)

DIY Cost: $120-$600 (parts only)

You Save: $330-$800 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 1.5-4.0 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.