🔧 Fuel Cap - Replacement

The fuel cap seals the fuel tank and helps prevent fuel vapor leaks and EVAP warning lights. On your Camry, replacement is simple: remove the old cap from the fuel filler neck and install the new one until it clicks.

Difficulty Level: Beginner | Estimated Time: 0.1-0.2 hours

---

⚠️ Safety & Precautions

• Work with the engine off and the vehicle parked.
• Do not smoke or work near open flames.
• Fuel vapors can irritate your eyes and skin.
• No battery disconnect is required.

---

🔧 Required Tools

You'll need the following tools for this repair:

• None required
• Clean shop towel
• Safety glasses
• Gloves

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Fuel cap - Qty: 1

---

📋 Before You Begin

• Park on level ground and turn the engine off.
• Open the fuel door and let the area cool if the car was recently driven.
• Inspect the fuel filler neck for dirt or damage before installing the new cap.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Remove the old cap

• Turn the fuel cap counterclockwise by hand until it comes free.
• If it is stuck, use a clean shop towel for a better grip.
• Check the tether and sealing ring for damage.

Step 2: Inspect the filler neck

• Look at the fuel filler neck for dirt, cracks, or rust.
• Wipe the sealing surface clean with a shop towel.
• A clean seal helps prevent EVAP leaks.

Step 3: Install the new cap

• Place the new fuel cap on the filler neck.
• Turn it clockwise by hand until it clicks several times.
• Make sure it is fully seated and snug.

Step 4: Close the fuel door

• Close the fuel door carefully.
• Start the car later and confirm there is no check engine light for fuel cap issues.

---

✅ After Repair

• Drive normally and recheck that the cap stays tight.
• If the check engine light was on, it may take a few drive cycles to clear after a proper repair.
• If the light stays on, the EVAP system may need diagnosis.

---

💰 DIY vs Shop Cost

Shop Cost: $40-$120 (parts + labor)

DIY Cost: $15-$40 (parts only)

You Save: $25-$80 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.1-0.2 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.