🔧 Fuel Cap - Replacement

Your Camry uses a sealed fuel system, so a damaged or loose fuel cap can trigger a check engine light and let fuel vapors escape. Replacing it is quick and simple, and it’s a good first fix if you see an evap system warning.

Difficulty Level: Beginner | Estimated Time: 0.1-0.2 hours

---

⚠️ Safety & Precautions

• Work with the ignition off and the engine cool.
• Do not smoke or work near open flames.
• Make sure the fuel filler neck is clean before installing the new cap.
• No battery disconnect is required.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Clean microfiber towel
• Nitrile gloves

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Fuel cap - Qty: 1

---

📋 Before You Begin

• Park on level ground and turn the ignition off.
• Open the fuel door fully before removing the old cap.
• Let the tank sit a few minutes if it was just filled.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Remove the old fuel cap

• Use your hand to turn the fuel cap counterclockwise until it comes free.
• Inspect the cap seal for cracks, flattening, or dirt.
• Check the fuel filler neck for dirt or damage.

Step 2: Clean the sealing area

• Use a clean microfiber towel to wipe the filler neck and cap sealing surface.
• Make sure no dust or grit is left behind.
• A clean seal helps prevent EVAP leaks.

Step 3: Install the new fuel cap

• Use your hand to thread the new cap onto the filler neck clockwise.
• Tighten until it clicks several times or feels fully seated.
• Do not use tools or overtighten it.

Step 4: Close the fuel door

• Close the fuel door and make sure it latches properly.

---

✅ After Repair

• Start the engine and check that the fuel cap warning is gone.
• If the check engine light was on, it may take a few drive cycles to clear if an EVAP code was stored.
• Recheck the cap after your next fuel stop to make sure it is still tight.

---

💰 DIY vs Shop Cost

Shop Cost: $60-$130 (parts + labor)

DIY Cost: $15-$35 (parts only)

You Save: $45-$95 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.1-0.2 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.