🔧 Engine Air Filter - Replacement

The engine air filter on your Silverado keeps dirt out of the intake system. Replacing it is a quick job and helps maintain airflow, throttle response, and fuel economy.

Difficulty Level: Beginner | Estimated Time: 0.2-0.5 hours

---

⚠️ Safety & Precautions

• Engine should be off and cool before starting.
• Keep tools and loose items away from the intake opening.
• Do not drive with the airbox unclipped or unsealed.

---

🔧 Required Tools

You'll need the following tools for this repair:

• No tools required
• Clean shop towel
• Gloves
• Safety glasses

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Engine air filter - Qty: 1

---

📋 Before You Begin

• Park on level ground and set the parking brake.
• Turn the ignition off.
• Open the hood and locate the air filter box on the engine bay.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Open the air filter box

• Find the black plastic airbox and release the retaining clips by hand.
• If a clamp or screw is present, use the appropriate hand pressure or tool to loosen it.
• Work gently so the clips do not break.

Step 2: Remove the old filter

• Lift the old engine air filter straight out of the airbox.
• Check for dirt, leaves, or debris in the housing.
• Use a clean shop towel to wipe out the airbox if needed.

Step 3: Install the new filter

• Place the new engine air filter into the housing in the same orientation as the old one.
• Make sure the rubber seal sits flat all the way around.
• Do not force it.

Step 4: Close and secure the airbox

• Lower the airbox lid into place.
• Reinstall or snap in all retaining clips by hand.
• Make sure the housing is fully closed and seated evenly.

---

✅ After Repair

• Start the engine and listen for any hissing or abnormal intake noise.
• Check that the airbox is fully latched.
• Make sure no tools or rags were left in the engine bay.

---

💰 DIY vs Shop Cost

Shop Cost: $60-$120 (parts + labor)

DIY Cost: $20-$35 (parts only)

You Save: $40-$85 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.