🔧 Engine Air Filter - Replacement

The engine air filter on your Camry keeps dirt and dust out of the intake system. Replacing it is a simple maintenance job that helps keep airflow steady and the engine running efficiently.

Difficulty Level: Beginner | Estimated Time: 10-15 minutes

---

⚠️ Safety & Precautions

• Park on a level surface and set the parking brake.
• Let the engine cool down before opening the air box.
• Make sure the air filter housing clips and snorkel are fully seated after reassembly to avoid unfiltered air entering the engine.
• No battery disconnect is required for this repair.

---

🔧 Required Tools

You'll need the following tools for this repair:

• No special tools required
• Gloves
• Safety glasses

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Engine air filter - Qty: 1

---

📋 Before You Begin

• Turn the engine off and remove the key/fob from the vehicle area.
• Open the hood and locate the air filter box on the engine side of the bay.
• Tip: Clean around the air box before opening it.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Open the air filter housing

• Release the metal clips on the air box cover by hand.
• If a hose clamp or small intake retainer is in the way, loosen it only if needed.
• Lift the top cover carefully so you do not crack the intake snorkel.

Step 2: Remove the old air filter

• Lift the old filter straight out of the housing.
• Check the filter box for leaves, dirt, or debris.
• Wipe the inside of the housing with a clean, dry cloth if needed.

Step 3: Install the new air filter

• Place the new filter into the housing in the same direction as the old one.
• Make sure the filter edge sits flat all the way around.
• Tip: A crooked filter can leak dirty air.

Step 4: Reinstall the air box cover

• Set the cover back into place and press it down evenly.
• Lock all retaining clips by hand until they snap shut.
• Confirm the cover is fully seated on every side.

---

✅ After Repair

• Start the engine and listen for any air leaks or rattles.
• Check that the air box is closed tightly.
• No scan tool or reset procedure is required.

---

💰 DIY vs Shop Cost

Shop Cost: $60-$130 (parts + labor)

DIY Cost: $20-$40 (parts only)

You Save: $40-$90 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.4 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.