🔧 Kicks - Engine Air Filter Replacement

The engine air filter cleans the air going into your engine. Replacing a dirty filter helps your Kicks breathe easier, maintain power, and protect the engine from dust and debris.

Difficulty Level: Beginner | Estimated Time: 0.2-0.5 hours

---

⚠️ Safety & Precautions

• ⚠️ Let the engine cool if it was just running to avoid burns.
• ⚠️ Keep fingers clear of the cooling fan area; it can turn on unexpectedly.
• ⚠️ No battery disconnect is required for this job on your Kicks.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Nitrile gloves
• Safety glasses
• Phillips #2 screwdriver
• Flat trim tool
• Flashlight

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Engine air filter - Qty: 1

---

📋 Before You Begin

• Park your Kicks on level ground and turn the engine off.
• Open the hood and make sure the engine area is well-lit (use a flashlight).
• Take a quick photo before removal.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Find the air filter box

• Locate the black plastic air filter housing (air box) near the engine.
• You’ll see metal clips and/or screws holding the lid down.

Step 2: Unclip or unscrew the air box lid

• Release the housing clips by hand.
• If your air box uses screws, remove them with a Phillips #2 screwdriver.
• If a clip is tight, gently pry with a flat trim tool (a plastic pry tool that helps avoid breaking clips).

Step 3: Open the air box and remove the old filter

• Lift the lid enough to access the filter (you usually don’t need to remove the whole lid).
• Pull the old air filter straight out.
• Use a flashlight to look inside the air box for leaves or dirt.

Step 4: Clean the air box sealing surface

• Wipe the inside edge where the filter seals using a clean rag (no tools required).
• Do not let debris fall down into the intake tube.

Step 5: Install the new engine air filter

• Install the new filter in the same direction as the old one.
• Make sure it sits flat and fully into the grooves so it seals all the way around.
• If it won’t sit flat, it’s misaligned.

Step 6: Close the air box and secure it

• Lower the lid and make sure it’s seated evenly.
• Reinstall screws with a Phillips #2 screwdriver (snug only; do not overtighten).
• Re-latch the clips by hand until they fully snap into place.

---

✅ After Repair

• Start your Kicks and let it idle for 10–20 seconds.
• Listen for whistling or hissing (a sign the air box isn’t sealed).
• Recheck that all clips/screws are secure and the lid is fully closed.

---

💰 DIY vs Shop Cost

Shop Cost: ₹800-₹2,000 (parts + labor)

DIY Cost: ₹400-₹1,200 (parts only)

You Save: ₹400-₹800 by doing it yourself!

Shop labor rates vary but typically run ₹600-₹1,500/hour. This repair takes a shop approximately 0.2-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.