🔧 F-250 Super Duty - Engine Air Filter Replacement

The engine air filter on your F-250 Super Duty sits inside the air filter box (air cleaner housing) under the hood. Replacing it helps your engine breathe properly and can improve performance and fuel economy if the old filter is dirty.

Difficulty Level: Beginner | Estimated Time: 0.2-0.5 hours

---

⚠️ Safety & Precautions

• ⚠️ Work on a cool engine so you don’t burn your hands.
• ⚠️ Keep dirt and leaves out of the open air box and intake tube.
• ⚠️ Do not start the engine with the filter removed.
• ⚠️ Battery disconnect is not required for this job.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Nitrile gloves
• Safety glasses
• Flathead screwdriver
• Shop vacuum
• Clean microfiber towel
• Flashlight

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Engine air filter - Qty: 1

---

📋 Before You Begin

• Park on level ground, shift to Park, and shut the engine off.
• Open the hood and let the engine bay cool for 10–15 minutes if it was running.
• Locate the air filter box (a black plastic box on the passenger-side of the engine bay with a large intake tube coming off it).

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Open the air filter box

• Put on nitrile gloves and safety glasses.
• Find the metal retaining clips around the edge of the air filter box lid.
• Unclip each retaining clip by hand; if a clip is stubborn, gently pry with a flathead screwdriver.
• Lift the air box lid enough to remove the filter. Don’t yank on any hoses.

Step 2: Remove the old air filter

• Pull the old filter straight up and out by hand.
• Use a flashlight to look inside the lower half of the air box for leaves, sand, or bugs.

Step 3: Clean the air box (quick and safe)

• Use a shop vacuum to vacuum debris out of the lower air box.
• Wipe the sealing edge (where the filter gasket sits) with a clean microfiber towel.
• Do not spray cleaner into the intake.

Step 4: Install the new air filter

• Place the new engine air filter into the lower air box the same way the old one came out.
• Make sure it sits fully flat and the rubber gasket seals all the way around.

Step 5: Close and latch the air filter box

• Lower the air box lid into place by hand, making sure it’s aligned evenly.
• Snap all retaining clips back on by hand.
• Do a quick visual check that the lid is fully seated all around (no gaps).

---

✅ After Repair

• Start the engine and let it idle for 15–30 seconds.
• Listen for any whistling/hissing that could indicate the air box lid isn’t clipped down evenly.
• Take a short test drive and re-check the clips if anything sounds unusual.

---

💰 DIY vs Shop Cost

Shop Cost: $50-$120 (parts + labor)

DIY Cost: $20-$45 (parts only)

You Save: $30-$75 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.