🔧 Sequoia - Engine Air Filter Replacement

The engine air filter on your Sequoia sits inside the air cleaner box under the hood. This is a quick maintenance item that helps keep dirt out of the engine and keeps airflow steady.

Difficulty Level: Beginner | Estimated Time: 0.2-0.5 hours

---

⚠️ Safety & Precautions

• Let the engine cool before working near the air box.
• Keep loose clothing and fingers away from the intake duct area.
• Do not start the engine with the air box open.
• No battery disconnect is required for this repair.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Flathead screwdriver
• Trim clip tool
• Gloves
• Safety glasses

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Engine air filter - Qty: 1

---

📋 Before You Begin

• Park on level ground and set the parking brake.
• Open the hood and make sure the engine is off.
• Have the new air filter ready before opening the air box.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Open the hood

• Pull the hood release inside the cabin, then lift the hood and secure it.
• Use no tool for this step.

Step 2: Locate the air cleaner box

• Find the large black air box on the passenger side of the engine bay.
• This is the housing that contains the engine air filter.

Step 3: Release the air box cover

• Use a flathead screwdriver or trim clip tool to release the air box clips if needed.
• Lift the cover carefully and do not force it.

Step 4: Remove the old filter

• Lift the old air filter straight out of the housing by hand.
• Note the filter’s orientation before removal.

Step 5: Clean the air box

• Use a clean cloth to wipe out any dust or leaves from the air box.
• Make sure nothing falls into the intake opening.

Step 6: Install the new filter

• Set the new engine air filter into the housing in the same direction as the old one.
• Make sure the filter edge sits flat all the way around.

Step 7: Reinstall the air box cover

• Lower the cover into place and secure all clips by hand or with the flathead screwdriver if needed.
• There is no torque spec for the cover clips.

Step 8: Final check

• Close the hood and make sure it latches fully.
• Start the engine and listen for any unusual air leaks or whistling.

---

✅ After Repair

• Make sure the hood is fully latched.
• Check that the air box cover is seated evenly all the way around.
• Inspect again after a short drive if you hear any intake noise.

---

💰 DIY vs Shop Cost

Shop Cost: ₹1,500-₹3,500 (parts + labor)

DIY Cost: ₹700-₹1,800 (parts only)

You Save: ₹800-₹1,700 by doing it yourself!

Shop labor rates vary but typically run ₹1,000-₹2,500/hour. This repair takes a shop approximately 0.2-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.