🔧 Rogue - Engine Air Filter Replacement

Replacing the engine air filter keeps clean air flowing into your engine. A clogged filter can reduce power and fuel economy and may cause the engine to run poorly.

Difficulty Level: Beginner | Estimated Time: 10-20 minutes

---

⚠️ Safety & Precautions

• ⚠️ Work with the engine off and cool to avoid burns.
• ⚠️ Keep tools and fingers away from the radiator fan area; it can turn on unexpectedly.
• ⚠️ No battery disconnect is required for this job.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Clean nitrile gloves
• Safety glasses
• Small flathead screwdriver
• Flashlight

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Engine air filter - Qty: 1

---

📋 Before You Begin

• 🅿️ Park on level ground, shift to Park, and set the parking brake.
• Open the hood and let the engine cool for 10-15 minutes if it was running.
• Take a quick photo before disassembly.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Locate the air filter box

• Find the black plastic air filter housing near the engine, connected to the large intake tube.
• Use a flashlight to clearly see the metal clips or screws on the housing.

Step 2: Release the air box cover

• Most Rogue housings use metal spring clips: flip them open by hand. If tight, gently pry with a small flathead screwdriver.
• If your housing uses screws instead, loosen them with the small flathead screwdriver until the cover can lift.
• Don’t force it—clips should pop free.

Step 3: Remove the old air filter

• Lift the air box lid just enough to pull the filter out (you usually don’t need to remove the whole lid).
• Pull the filter straight out and note how it sits (the rubber edge/seal should face the housing lip).
• Use the flashlight to check inside the lower box for leaves or dirt.

Step 4: Clean the air box seating area

• With the filter removed, wipe the sealing surface with a clean glove (use clean nitrile gloves).
• If you see debris, carefully lift it out by hand—don’t push anything into the intake tube.

Step 5: Install the new air filter

• Place the new filter into the lower air box in the same orientation as the old one.
• Make sure the filter sits flat and the rubber seal is fully seated all the way around.
• If it rocks or pinches, it’s not seated.

Step 6: Close and secure the air box

• Lower the lid back into place without disturbing the filter.
• Snap the clips closed by hand, or tighten the screws with the small flathead screwdriver until snug.
• Torque to: Not applicable (snug only; do not overtighten plastic).

---

✅ After Repair

• Start the engine and let it idle for 10-20 seconds.
• Listen for whistling or hissing (can mean the air box isn’t fully clipped/sealed).
• Do a quick visual check that all clips are latched and the intake tube is still seated.

---

💰 DIY vs Shop Cost

Shop Cost: $40-$90 (parts + labor)

DIY Cost: $15-$35 (parts only)

You Save: $25-$55 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.4 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.