🔧 Air Filter - Replacement

The engine air filter on your 1500 is a routine maintenance item that keeps dirt out of the intake system. Replacing it helps maintain airflow and can improve drivability if the old filter is dirty or clogged.

Difficulty Level: Beginner | Estimated Time: 0.2-0.5 hours

---

⚠️ Safety & Precautions

• Let the engine cool down before working near the air box.
• Keep tools, screws, and debris out of the intake opening.
• Do not run the engine with the air box open.
• No battery disconnect is required for this job.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Flat-blade screwdriver
• 10mm socket
• 1/4-inch ratchet
• Work light
• Safety glasses
• Gloves

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Engine air filter - Qty: 1

---

📋 Before You Begin

• Park on level ground and set the parking brake.
• Open the hood and make sure the engine is off.
• Clean around the air box before opening it so dirt does not fall inside.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Open the hood and locate the air box

• Use the hood release inside the cab, then secure the hood with the prop rod.
• Find the black plastic air box near the engine intake tubing.
• Blow or wipe off loose dirt first.

Step 2: Release the air box cover

• Use a flat-blade screwdriver or your hand to release the air box clips.
• If your cover uses screws, use a 10mm socket and 1/4-inch ratchet to remove them.
• Lift the cover straight up carefully.

Step 3: Remove the old air filter

• Lift the old filter out of the air box.
• Check the air box for leaves, dirt, or bugs.
• Do not let anything fall into the intake opening.

Step 4: Install the new air filter

• Place the new engine air filter into the air box in the same direction as the old one.
• Make sure the filter sits flat and the sealing edge is fully seated.
• A crooked filter can let dirty air leak past.

Step 5: Reinstall the air box cover

• Set the cover back on the air box carefully.
• Reinstall and tighten the clips or screws using the same flat-blade screwdriver or 10mm socket.
• No torque spec is normally required for the air box cover.

Step 6: Final check

• Close the hood.
• Start the engine and listen for any unusual air leaks or whistling.
• If the check engine light is on, recheck that the air box is fully sealed.

---

✅ After Repair

• Make sure the engine idles normally.
• Verify the air box cover is fully latched.
• Inspect the old filter to see how dirty it was; this helps you track service intervals.

---

💰 DIY vs Shop Cost

Shop Cost: $65-$120 (parts + labor)

DIY Cost: $15-$40 (parts only)

You Save: $50-$80 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.