🔧 Engine Air Filter - Replacement

The engine air filter on your Camry is easy to service and helps keep dust and debris out of the engine. Replacing it on time can improve airflow and keep the engine running smoothly.

Difficulty Level: Beginner | Estimated Time: 0.2-0.5 hours

---

⚠️ Safety & Precautions

• Make sure the engine is off and cool before opening the air box.
• Keep dirt, leaves, and small debris out of the air intake opening.
• Do not force the air filter cover if the clips or tabs feel stuck.

---

🔧 Required Tools

You'll need the following tools for this repair:

• No tools required
• Safety glasses
• Gloves

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Engine air filter - Qty: 1

---

📋 Before You Begin

• Park on level ground and set the parking brake.
• Turn the ignition off and let the engine cool.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Open the air filter housing

• Open the hood and locate the black air filter box near the top of the engine bay.
• Release the metal clips or loosen the housing fasteners by hand.
• Lift the cover carefully without pulling hard on any attached intake duct.

Step 2: Remove the old filter

• Use your hands to lift the old filter straight out of the housing.
• Check the housing for leaves, dirt, or bugs and remove them by hand.
• Keep debris out of the intake.

Step 3: Install the new filter

• Place the new engine air filter into the housing in the same direction as the old one.
• Make sure the filter sits flat all the way around the edge.
• Use your hands to press the cover back into place.

Step 4: Secure the housing

• Reinstall or snap closed all clips and fasteners by hand.
• Make sure the cover is fully seated and sealed all the way around.
• Check that no hoses or wiring were pinched during reassembly.

---

✅ After Repair

• Start the engine and listen for any abnormal intake noises.
• Confirm the air box is fully closed and secure.
• Recheck the cover after a short drive if needed.

---

💰 DIY vs Shop Cost

Shop Cost: $60-$120 (parts + labor)

DIY Cost: $15-$35 (parts only)

You Save: $45-$85 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.