🔧 Air Filter - Replacement

Your engine air filter keeps dirt and debris out of the intake. On your Ram, this is a simple maintenance job and usually takes just a few minutes with basic hand tools.

Difficulty Level: Beginner | Estimated Time: 0.5-1 hour

---

⚠️ Safety & Precautions

• Make sure the engine is off and cool before starting.
• Do not leave the air box open longer than needed. Keep dirt out of the intake.
• Battery disconnect is not required for this repair.
• Work clean to protect the engine.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Gloves
• Safety glasses
• Flathead screwdriver

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Engine air filter - Qty: 1

---

📋 Before You Begin

• Park on level ground and set the parking brake.
• Turn the ignition off and let the engine cool.
• Open the hood and locate the air filter box near the engine bay.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Open the air box

• Locate the air filter housing and release the retaining clips by hand.
• If a clip is tight, use a flathead screwdriver gently to lift it free.
• Lift the air box lid carefully and set it aside.
• Do not force the cover.

Step 2: Remove the old filter

• Lift the old engine air filter straight out of the housing.
• Check the inside of the air box for leaves, dirt, or debris.
• Wipe out any loose debris with a clean cloth if needed.

Step 3: Install the new filter

• Place the new engine air filter into the housing in the same direction as the old one.
• Make sure the filter sits flat and fully seals around the edges.
• If it does not sit flush, remove it and reposition it.

Step 4: Close the air box

• Reinstall the air box lid and make sure the cover lines up correctly.
• Press or clip the retaining clips back into place by hand.
• Confirm the air box is fully sealed all the way around.

---

✅ After Repair

• Start the engine and listen for any abnormal air leaks or whistling.
• Make sure the air box lid is fully seated and clipped shut.
• Dispose of the old filter properly.

---

💰 DIY vs Shop Cost

Shop Cost: $70-$140 (parts + labor)

DIY Cost: $20-$45 (parts only)

You Save: $50-$95 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.3-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.