🔧 Engine Air Filter - Replacement

Replacing the engine air filter helps keep dirt out of the intake and can restore airflow if the old filter is clogged. On your Ram, this is a quick service and usually takes only a few minutes.

Difficulty Level: Beginner | Estimated Time: 0.2-0.5 hours

---

⚠️ Safety & Precautions

• Let the engine cool down before opening the air box.
• Make sure no dirt, leaves, or loose debris fall into the air intake.
• Do not drive with the air box left open.
• No battery disconnect is required for this repair.

---

🔧 Required Tools

You'll need the following tools for this repair:

• No special tools required
• Gloves
• Safety glasses

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Engine air filter - Qty: 1

---

📋 Before You Begin

• Park on level ground and set the parking brake.
• Turn the ignition off and remove the key or fob from the vehicle.
• Open the hood and locate the air filter box near the engine bay.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Open the air filter housing

• Release the air box clips or fasteners by hand.
• Lift the top of the air filter housing carefully.
• Keep the lid clean.

Step 2: Remove the old air filter

• Lift the old filter straight out of the air box.
• Check the housing for dirt, leaves, or debris.
• If needed, wipe the inside of the air box clean with a dry cloth.

Step 3: Install the new air filter

• Place the new filter into the housing the same way the old one came out.
• Make sure the filter sits flat and the edge seal is fully seated.
• Do not force the filter.

Step 4: Reinstall the air box lid

• Lower the top half of the housing back into place.
• Reattach all clips or fasteners by hand.
• Make sure the box is fully closed all the way around.

---

✅ After Repair

• Start the engine and listen for any unusual intake noises.
• Make sure the air box is sealed properly.
• Confirm the hood is fully latched before driving.

---

💰 DIY vs Shop Cost

Shop Cost: $60-$120 (parts + labor)

DIY Cost: $20-$45 (parts only)

You Save: $40-$75 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.