🔧 Engine Air Filter - Replacement

Replacing the engine air filter on your Sierra is quick and simple. A clean filter helps the engine breathe properly and keeps dirt out of the intake system. This is a good beginner job and usually takes just a few minutes.

Difficulty Level: Beginner | Estimated Time: 0.2-0.5 hours

---

⚠️ Safety & Precautions

• Turn the engine off and let it cool before opening the air box.
• Keep loose dirt, leaves, and tools away from the intake opening.
• Do not start the engine with the air box open.
• No battery disconnect is required for this repair.

---

🔧 Required Tools

You'll need the following tools for this repair:

• No special tools required
• Gloves
• Safety glasses

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Engine air filter - Qty: 1

---

📋 Before You Begin

• Park on level ground and set the parking brake.
• Open the hood and make sure the engine is off.
• Clean around the air box before opening it so dirt does not fall inside.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Open the air filter housing

• Locate the air filter box on the driver side of the engine bay.
• Release the metal clips on the air box lid by hand.
• Lift the lid carefully and move it aside without stressing the intake duct.

Step 2: Remove the old air filter

• Lift the old filter straight out of the housing.
• Check the housing for dirt, leaves, or debris.
• Keep debris out of the intake opening.

Step 3: Install the new air filter

• Place the new filter into the housing in the same direction as the old one.
• Make sure the filter edge sits fully in the sealing groove all the way around.
• The filter should sit flat with no gaps or pinches.

Step 4: Reassemble the air box

• Put the lid back on the air box.
• Press the clips down until they lock.
• Check that the lid is fully seated on all sides.

---

✅ After Repair

• Start the engine and listen for any unusual intake noise.
• Make sure the air box is closed tightly with all clips secured.
• Check that no tools or rags were left in the engine bay.

---

💰 DIY vs Shop Cost

Shop Cost: $50-$120 (parts + labor)

DIY Cost: $15-$40 (parts only)

You Save: $35-$80 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.