🔧 Cabin Air Filter - Replacement

Your cabin air filter cleans the air coming into the interior through the HVAC system. On your Camry, this is a simple glove box-area service that restores airflow and helps reduce dust and odors.

Difficulty Level: Beginner | Estimated Time: 0.3-0.5 hours

---

⚠️ Safety & Precautions

• Turn the ignition off before starting.
• Keep fingers clear of the glove box hinges and damper arm.
• Do not force the filter cover or glove box; the plastic tabs can break.
• No battery disconnect is required.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Flat trim tool
• Flashlight
• Gloves

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Cabin air filter - Qty: 1

---

📋 Before You Begin

• Park on level ground and set the parking brake.
• Make sure the climate control is off.
• Open the passenger-side door for easier access.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Open the glove box

• Open the glove box and remove any items inside.
• Use your hands to lower the glove box fully.
• Work slowly to avoid broken tabs.

Step 2: Release the glove box stop tabs

• Use a flat trim tool if needed to gently press the side walls of the glove box inward.
• Let the glove box swing down farther until it hangs open.
• This exposes the cabin filter housing behind it.

Step 3: Remove the cabin filter cover

• Use your hands to unclip the filter access cover.
• Pull the cover straight off and set it aside.
• Note the direction of the old filter’s airflow arrow before removal.

Step 4: Remove the old filter

• Pull the old cabin air filter straight out.
• If it is dirty or folded, keep it level so debris does not fall out.
• Vacuum loose leaves before installing the new filter.

Step 5: Install the new filter

• Slide the new cabin air filter into the housing in the same direction as the airflow arrow.
• Make sure it seats flat and is not bent.
• Do not pinch the filter pleats.

Step 6: Reinstall the cover and glove box

• Snap the filter cover back into place by hand.
• Lift the glove box back up and re-engage the side stops.
• Close the glove box slowly and verify it opens and closes normally.

---

✅ After Repair

• Turn the blower fan on and check for stronger airflow.
• Listen for any rattles from the glove box area.
• If airflow is still weak, confirm the filter is installed with the correct airflow direction.

---

💰 DIY vs Shop Cost

Shop Cost: $60-$120 (parts + labor)

DIY Cost: $15-$35 (parts only)

You Save: $45-$85 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.3-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.