🔧 Palisade - Taillight Bulb Replacement

Your Palisade can have different rear lamp designs depending on which function you mean (tail/brake, turn signal, reverse, or the small license-plate lights). Some are replaceable bulbs, and some trims use LED modules that don’t use a “bulb.”

Difficulty Level: Beginner | Estimated Time: 0.5-1.0 hours

---

⚠️ Safety & Precautions

• ⚠️ Let the rear lamps cool before touching bulbs or housings.
• ⚠️ Turn the vehicle OFF and remove the key/fob from the area.
• ⚠️ Don’t touch a new bulb’s glass with bare fingers; use gloves.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Trim removal tool set
• Phillips screwdriver #2
• 10mm socket
• 1/4" drive ratchet
• Small flat-blade screwdriver
• Nitrile gloves
• Safety glasses
• Flashlight

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Rear turn signal bulb - Qty: 2
• Rear reverse light bulb - Qty: 2
• Tail/brake light bulb - Qty: 2
• Tail lamp housing clip set - Qty: 1

---

📋 Before You Begin

• 🧩 Quick check: Which lights are you replacing—turn signals, reverse, or tail/brake?
• 🧩 Are the lights on the outer body (quarter panel) or on the liftgate (inner)?

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Confirm the exact bulb location

• Turn the vehicle ON and use a helper to operate the function you’re replacing (brake pedal, turn signal, or shift to Reverse with brake held).
• Use a flashlight to confirm whether the failed light is in the outer lamp or liftgate lamp.
• Reply with the function + location, and I’ll tailor the exact steps.

Step 2: Stop here until confirmed

• Hyundai uses different access points and, in some cases, LED assemblies that don’t have a replaceable bulb.
• Once you confirm the two answers above, I’ll give you the exact removal points, bulb type, and reassembly steps for your Palisade.

---

✅ After Repair

• Verify the repaired lights work (both sides, same function).
• Confirm the lamp housing is fully seated and gaps are even.

---

💰 DIY vs Shop Cost

Shop Cost: $60-$180 (parts + labor)

DIY Cost: $10-$60 (parts only)

You Save: $50-$120 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.5-1.0 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.