🔧 Rear Turn Signal Bulbs - Bulb Replacement

On your Rogue, the rear turn signal bulb is accessed from inside the cargo area through the tail lamp service opening. This is a simple job if you work carefully and avoid touching the new bulb glass with bare fingers.

Difficulty Level: Beginner | Estimated Time: 0.5-1 hour

---

⚠️ Safety & Precautions

• Turn the ignition off and remove the key/fob before starting.
• Let the bulbs cool before touching the lamp housing.
• Use care around the painted body edge so you do not scratch the lamp or quarter panel.
• Do not force the bulb holder; twist gently to unlock it.
• If the lamp connector is stiff, do not pull on the wires.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Trim panel removal tool
• Flat plastic pry tool
• Gloves
• Safety glasses
• Clean microfiber cloth

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Rear turn signal bulb - Qty: 2

---

📋 Before You Begin

• Park on level ground and set the parking brake.
• Open the liftgate and clear the cargo area so you can reach the rear lamp access area.
• Keep the new bulb in its packaging until you are ready to install it.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Open the cargo access area

• Open the liftgate and move to the side of the vehicle with the failed rear turn signal bulb.
• Use your hands to remove any cargo items blocking the rear lamp access area.

Step 2: Remove the tail lamp access cover

• Use a flat plastic pry tool or trim panel removal tool to gently pop off the rear lamp access cover inside the cargo area.
• Work slowly so you do not crack the plastic cover.
• Take your time at the edge clips.

Step 3: Remove the bulb holder

• Locate the rear turn signal bulb socket behind the lamp housing.
• Use your hand to twist the socket counterclockwise and pull it straight out.
• If needed, wear gloves for better grip.

Step 4: Replace the bulb

• Pull the old bulb straight out of the socket.
• Install the new bulb into the socket with a gentle push.
• Use a clean microfiber cloth to avoid touching the glass with bare fingers.
• Hold the bulb by the base.

Step 5: Reinstall the bulb holder

• Insert the socket back into the lamp housing.
• Use your hand to twist it clockwise until it locks in place.
• Make sure it sits fully seated and secure.

Step 6: Reinstall the access cover

• Align the cover with the opening.
• Use your hand to press it back into place until the clips snap in.
• Check that the cover is flush with the trim.

Step 7: Test the new bulb

• Turn the ignition on.
• Activate the turn signal and confirm the bulb flashes normally.
• Repeat on the other side if you are replacing both bulbs.

---

✅ After Repair

• Check both rear turn signals for proper flash rate.
• Verify the brake lights and tail lights still work normally.
• If the bulb does not light, remove it and recheck seating in the socket.
• Replace bulbs in pairs so both sides match brightness and color.

---

💰 DIY vs Shop Cost

Shop Cost: $80-$180 (parts + labor)

DIY Cost: $10-$30 (parts only)

You Save: $70-$150 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.5-1 hour.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.