🔧 Camry - Headlight Bulb Replacement

On your Camry, the main low/high beam headlights are factory LED projector units, which are not simple plug-in bulbs like older halogen lights. Usually, only the smaller headlight-related bulbs (like turn signal or parking/position bulbs) are user-replaceable.

Difficulty Level: Intermediate | Estimated Time: 0.5–1 hour

---

⚠️ Safety & Precautions

• ⚠️ Please confirm what you want to change: Are you trying to replace the main low/high beam LED modules, or the smaller bulbs (turn signal / parking / position lights) inside the headlight?
• ⚠️ If you mean the main LED low/high beam, that is a sealed LED module; Toyota recommends replacing the entire headlamp assembly, which is an advanced job and not like swapping a bulb.

---

🔧 Required Tools

You'll need the following tools for this repair (once you confirm which bulbs):

• 🔹10mm socket
• 🔹Ratchet handle
• 🔹Short extension 3"
• 🔹Flat trim removal tool (plastic)
• 🔹Phillips #2 screwdriver
• 🔹Latex or nitrile gloves
• 🔹Safety glasses
• 🔹Work light or flashlight

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• 🔹Front headlight LED assembly (left or right) - Qty: 1 each side, if replacing full unit
• 🔹Front turn signal bulb (amber) - Qty: 2 (replace in pairs)
• 🔹Front parking/position light bulb - Qty: 2 (replace in pairs)
• 🔹New headlamp housing clips - Qty: 4–8

---

📋 Before You Begin

• Park your Camry on level ground and set the parking brake.
• Switch the headlight switch to OFF and remove the key or switch off the ignition.
• If working near any wiring connectors, disconnect the negative battery cable using a 10mm socket for extra safety.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Confirm which light you’re replacing

• Turn the headlights on and walk to the front of your Camry.
• Look at which light is not working: the main bright projector beam, the small parking/position light, or the amber turn signal.
• This decides if it’s a simple bulb or full assembly.

Step 2: Tell me exactly which light is out

• Reply with: “Low/high beam LED out” or “Turn signal bulb out” or “Small parking/position bulb out” and which side (left/right).
• Once you confirm, I’ll give you the exact, detailed steps just for that bulb or assembly on your Camry, with simple instructions and photos in mind.

---

✅ After Repair

• Test all front lights: low beam, high beam, parking/position, and turn signals.
• Check that no warning lights appear on the dash.
• At night, confirm the beam pattern looks even and aimed correctly.

---

💰 DIY vs Shop Cost

Shop Cost: For bulb: $80–$150. For full LED headlamp assembly: $700–$1,200 per side (parts + labor)

DIY Cost: Bulb: $10–$40. Full LED assembly: $350–$700 per side (parts only)

You Save: Around $50–$500+ depending on whether it’s just a bulb or a full assembly.

Shop labor rates vary but typically run $100–$150/hour. This repair takes a shop approximately 0.5–2.0 hours depending on bulb vs full assembly.

---

🎯 Ready to get started?

Reply with which exact front light is out and I’ll walk you through the precise step‑by‑step for your Camry. HowToo can then ship the correct parts and any tools you’re missing right to you.