🔧 Edge - Headlight Bulb Replacement

On your Edge, the bulb replacement method depends on which headlamp system you have (halogen-bulb housing vs LED headlamp assembly). The access points and what’s replaceable are different, so I want to point you to the exact correct steps.

Difficulty Level: Beginner | Estimated Time: 0.5-1.5 hours

---

⚠️ Safety & Precautions

• Let the headlights cool fully; bulbs and housings get very hot.
• Do not touch the glass of a halogen bulb with bare fingers; oils can shorten bulb life.
• Turn the headlight switch OFF and remove the key/fob from the vehicle area before unplugging anything.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Nitrile gloves
• Safety glasses
• Flashlight
• Trim clip remover tool
• Flat-blade screwdriver (small)
• 8mm socket
• 10mm socket
• 1/4" ratchet
• 6" extension

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Headlight bulb(s) - Qty: 2

---

📋 Before You Begin

• Park on level ground, shift to Park, and set the parking brake.
• Open the hood and support it securely.
• If you’re replacing halogen bulbs, put on nitrile gloves before handling the new bulbs. Gloves prevent skin oil on glass.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Confirm which “headlight bulb” you mean

• Are you replacing low beams, high beams, or both low + high?
• Also, do your headlamps have a visible replaceable bulb with a twist-lock cap behind the housing (halogen), or are they a mostly sealed LED headlamp assembly (no bulb access cap)?

Step 2: I’ll give you the exact steps for your setup

• Reply with: (1) low/high/both, and (2) halogen-with-bulb-access vs LED-assembly.
• Once you confirm, I’ll lay out the exact left/right procedure, including whether your Edge needs airbox/cover removal for access.

---

✅ After Repair

• Turn headlights ON and confirm both sides illuminate and match in color/brightness.
• Check high/low beam operation (and auto high-beam if equipped).
• Make sure any caps/covers are fully seated to keep moisture out.

---

💰 DIY vs Shop Cost

Shop Cost: $120-$300 (parts + labor)

DIY Cost: $30-$160 (parts only)

You Save: $90-$140 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.5-1.0 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.