🔧 Land Cruiser - Front Wiper Blade Replacement

Replacing the front wiper blades restores clear visibility and helps prevent streaking, chatter, and skipped spots in rain. This is a quick, beginner-friendly job that usually takes only a few minutes per side.

Difficulty Level: Beginner | Estimated Time: 0.2-0.5 hours

---

⚠️ Safety & Precautions

• Turn the ignition off before lifting the wiper arms.
• Lift one wiper arm at a time so it does not snap back against the glass.
• Use a towel on the windshield in case the arm slips.
• No battery disconnect is required.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Microfiber towel
• Gloves
• Safety glasses

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Front wiper blades - Driver: 26", Passenger: 19" - Qty: 2

---

📋 Before You Begin

• Park on level ground with the ignition off.
• Set the parking brake.
• Lift one wiper arm at a time to avoid scratching the windshield.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Raise the wiper arm

• Use your hand to lift the driver-side wiper arm away from the windshield.
• Place a microfiber towel on the glass under the arm as a backup.
• Hold the arm firmly at all times.

Step 2: Remove the old blade

• Look for the small release tab where the blade connects to the arm.
• Press the tab with your fingers and slide the blade down and off the hook or pin.
• If it feels stuck, wiggle it gently instead of forcing it.

Step 3: Install the new blade

• Align the new blade with the wiper arm connector.
• Slide it into place until you hear or feel a click.
• Pull lightly on the blade to make sure it is locked in.

Step 4: Repeat on the passenger side

• Use the same hand removal and installation process for the passenger-side blade.
• Make sure the passenger blade matches the shorter blade size.

Step 5: Lower the wiper arms carefully

• Guide each arm back down to the windshield slowly.
• Do not let it drop onto the glass.

---

✅ After Repair

• Turn the wipers on and check for smooth movement.
• Spray washer fluid and confirm both blades clear the windshield cleanly.
• Make sure the blades sit flat against the glass with no lifting or chatter.

---

💰 DIY vs Shop Cost

Shop Cost: $60-$140 (parts + labor)

DIY Cost: $25-$60 (parts only)

You Save: $35-$80 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.3 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.