🔧 Front Windshield Wipers - Replacement

Your Tacoma uses a simple hook-style wiper arm, so this is a quick swap. The main job is choosing the correct blade length and locking each new blade fully into the arm.

Difficulty Level: Beginner | Estimated Time: 15-30 minutes

---

⚠️ Safety & Precautions

• Keep the wiper arm under control when removing the old blade. A bare metal arm can snap against the glass and crack the windshield.
• Work with the ignition off and the wipers parked.
• If the arms are lifted away from the glass, support them gently.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Clean microfiber towel
• Small flat-blade screwdriver
• Safety glasses

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Front wiper blade - Driver: 22" - Qty: 1
• Front wiper blade - Passenger: 20" - Qty: 1

---

📋 Before You Begin

• Park on level ground and turn the ignition off.
• Make sure the wipers are parked at the bottom of the windshield.
• Lift one wiper arm at a time.
• Place a towel on the glass under the arm for protection.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Lift the wiper arm

• Lift the wiper arm away from the windshield until it stays up on its own.
• Use a towel to protect the glass.

Step 2: Remove the old blade

• Use your hand to find the small release tab where the blade connects to the arm.
• Press the release tab and slide the blade downward off the hook.
• If the tab is tight, use a small flat-blade screwdriver carefully to press the release.

Step 3: Compare the new blade

• Match the new blade length to the side you are installing.
• Check that the connector style matches the hook on the arm.
• Do not force the wrong connector.

Step 4: Install the new blade

• Slide the wiper arm hook into the blade connector.
• Pull the blade upward until it clicks into place.
• Tug gently on the blade to make sure it is locked on.

Step 5: Lower the arm carefully

• Lower the arm back onto the windshield slowly.
• Repeat the same steps on the other side.
• Never let the bare arm snap down.

---

✅ After Repair

• Turn the wipers on and test both blades.
• Check for streaking, skipping, or loose attachment.
• If a blade chatters, clean the windshield and the rubber edge with a microfiber towel.

---

💰 DIY vs Shop Cost

Shop Cost: $45-$95 (parts + labor)

DIY Cost: $18-$45 (parts only)

You Save: $27-$50 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.