🔧 Grand Cherokee - Front Windshield Wiper Blade Replacement

Replacing the front wiper blades is a quick job that restores clear visibility in rain and spray. On your Grand Cherokee, the front blades use a hook-style attachment, so the swap is straightforward once the old blades are released.

Difficulty Level: Beginner | Estimated Time: 0.2-0.5 hours

---

⚠️ Safety & Precautions

• Turn the ignition off and keep the wipers parked before starting.
• Lift one wiper arm at a time so it does not snap back onto the glass.
• Protect the windshield with a towel if you are nervous about the arm falling.
• No battery disconnect is required.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Microfiber towel
• Safety glasses
• Gloves

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Front wiper blades - Driver: 22", Passenger: 21" - Qty: 2

---

📋 Before You Begin

• Park on level ground with the wipers switched off and in the normal parked position.
• Make sure the windshield is clean so you can check blade contact after installation.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Lift the wiper arm

• Carefully lift the driver-side wiper arm away from the windshield.
• Use your hand only; no tool is needed for this step.
• Lift the arm slowly.

Step 2: Remove the old blade

• Locate the small release tab where the blade connects to the hook on the arm.
• Press the release tab and slide the old blade downward to unhook it.
• If it is stuck, wiggle it gently while keeping the arm steady.

Step 3: Install the new blade

• Align the new blade's hook opening with the wiper arm hook.
• Slide the blade onto the arm until it clicks into place.
• Pull lightly on the blade to confirm it is locked.
• Listen for the click.

Step 4: Repeat on the passenger side

• Lift the passenger-side arm carefully.
• Remove the old blade using the same release tab.
• Install the new passenger blade and confirm it is locked.

Step 5: Test the wipers

• Lower both arms gently onto the windshield.
• Turn the ignition on and cycle the front wipers once.
• Check that both blades move smoothly and do not chatter.

---

✅ After Repair

• Spray washer fluid and confirm both blades clear the glass evenly.
• Listen for skipping, streaking, or uneven pressure.
• If one blade lifts or streaks, make sure it is fully locked to the arm.

---

💰 DIY vs Shop Cost

Shop Cost: ₹1,500-₹3,500 (parts + labor)

DIY Cost: ₹700-₹1,800 (parts only)

You Save: ₹800-₹1,700 by doing it yourself!

Shop labor rates vary but typically run ₹900-₹1,800/hour. This repair takes a shop approximately 0.2-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.