🔧 Front Wiper Blades - Replacement

Replacing the front wiper blades is a quick maintenance job that restores clear visibility and helps prevent streaking. On your RAV4, the blade swap is simple and does not require any battery disconnect or special vehicle setup.

Difficulty Level: Beginner | Estimated Time: 0.5-1 hour

---

⚠️ Safety & Precautions

• Keep the wiper arms away from the glass while the blades are removed.
• Do not let a bare wiper arm snap back onto the windshield.
• Work with the ignition off and the wipers fully parked.
• If needed, place a towel on the windshield for extra protection.

---

🔧 Required Tools

You'll need the following tools for this repair:

• None required
• Microfiber towel
• Safety glasses
• Gloves

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Front wiper blade - Driver: 26", Qty: 1
• Front wiper blade - Passenger: 16", Qty: 1

---

📋 Before You Begin

• Park on level ground.
• Turn the ignition off.
• Make sure the wipers are parked at the bottom of the windshield.
• Set a towel on the windshield if you want extra protection.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Lift the wiper arm

• Lift the driver-side wiper arm away from the windshield.
• Repeat for the passenger-side arm.
• Do one blade at a time.

Step 2: Remove the old blade

• Use your hand to press the small release tab on the wiper blade connector.
• Slide the blade downward and off the arm hook.
• Set the old blade aside.

Step 3: Install the new blade

• Slide the new blade onto the wiper arm hook until it clicks into place.
• Pull gently on the blade to confirm it is locked.
• Repeat for the other side.

Step 4: Lower the wiper arms

• Carefully place the arms back down on the glass.
• Make sure both blades sit flat on the windshield.

---

✅ After Repair

• Turn the ignition on and test the wipers with washer fluid.
• Check for smooth operation and no streaking.
• Confirm both blades clear the glass evenly.

---

💰 DIY vs Shop Cost

Shop Cost: $50-$100 (parts + labor)

DIY Cost: $25-$60 (parts only)

You Save: $25-$40 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.5-1 hour.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.