🔧 Front Windshield Wiper Blades - Replacement

The front wiper blades on your RAV4 are a simple clip-on replacement. This job takes only a few minutes and does not require any special disassembly if you lift the arms carefully and install the correct blade sizes.

Difficulty Level: Beginner | Estimated Time: 0.2-0.5 hours

---

⚠️ Safety & Precautions

• Turn the wipers fully off before starting.
• Keep the wiper arms secured so they do not snap onto the glass.
• Protect the windshield with a towel while the blade is off the arm.
• Do not let the metal arm hit the glass.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Clean towel
• Safety glasses
• Gloves

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Front wiper blades - Driver: 26", Passenger: 16" - Qty: 2

---

📋 Before You Begin

• Park on level ground with the ignition off.
• Make sure the wiper switch is in the OFF position.
• Lift only one wiper arm at a time.
• Place a towel on the glass first.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Lift the driver-side wiper arm

• Use your hand to lift the driver-side wiper arm away from the windshield.
• Place a towel on the windshield under the arm.

Step 2: Remove the old driver-side blade

• Press the release tab on the blade connector with your fingers.
• Slide the blade down and off the wiper arm hook.
• If the blade is stuck, wiggle it gently while keeping the arm steady.

Step 3: Install the new driver-side blade

• Align the new 26-inch front wiper blade with the hook on the arm.
• Slide it into place until it clicks.
• Pull lightly on the blade to make sure it is locked.

Step 4: Repeat on the passenger side

• Lift the passenger-side wiper arm carefully.
• Remove the old blade using the release tab and slide method.
• Install the new 16-inch front wiper blade until it clicks into place.

Step 5: Lower the wiper arms

• Lower both arms gently back onto the windshield.
• Remove the towel.
• Do not let the arm drop.

---

✅ After Repair

• Turn the ignition on and test the wipers at low speed.
• Check that both blades sweep smoothly and contact the glass evenly.
• If either blade chatters or streaks, remove and reseat it.

---

💰 DIY vs Shop Cost

Shop Cost: $45-$90 (parts + labor)

DIY Cost: $20-$45 (parts only)

You Save: $25-$45 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.