🔧 Camry - Front Windshield Wiper Blade Replacement

The front wiper blades on your Camry are quick to replace and usually snap off the wiper arm with a simple tab release. Fresh blades restore clear visibility in rain and reduce streaking, skipping, and chatter.

Difficulty Level: Beginner | Estimated Time: 0.2-0.5 hours

---

⚠️ Safety & Precautions

• Keep the wiper arm under control so it does not snap back onto the glass.
• Do not let the bare wiper arm hit the windshield.
• Turn the ignition off and make sure the wipers are fully at rest before starting.
• If the hood is open, keep hands clear of the cowl area near the wiper arms.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Safety glasses
• Work gloves
• Microfiber towel

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Front wiper blade, driver side 26" - Qty: 1
• Front wiper blade, passenger side 20" - Qty: 1

---

📋 Before You Begin

• Park on level ground and shut the vehicle off.
• Make sure the wiper switch is in the OFF position.
• Lift one wiper arm at a time to avoid scratching the glass.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Lift the driver-side wiper arm

• Use your hand to lift the driver-side wiper arm away from the windshield.
• Place a microfiber towel on the glass under the arm for extra protection.
• Keep a firm grip on the arm.

Step 2: Remove the old blade

• Press the release tab on the wiper blade connector with your fingers.
• Slide the old blade downward to unhook it from the arm.
• Set the old blade aside.

Step 3: Install the new driver-side blade

• Slide the new 26" wiper blade onto the arm until it clicks into place.
• Gently tug the blade to confirm it is locked on.
• Lower the arm carefully back onto the windshield.

Step 4: Replace the passenger-side blade

• Repeat the same release-and-slide method on the passenger side.
• Install the new 20" wiper blade and make sure it clicks firmly.
• Lower the arm slowly onto the glass.

Step 5: Test the wipers

• Turn the ignition on and run the wipers with washer fluid.
• Check that both blades sweep smoothly with no chatter or skipping.
• If one blade is loose, remove it and reinstall it until it locks.

---

✅ After Repair

• Spray washer fluid and confirm both blades clear the glass evenly.
• Check for any clicking, lifting, or streaking.
• Recheck blade fit after the first rain or wash.

---

💰 DIY vs Shop Cost

Shop Cost: ₹1,200-₹2,500 (parts + labor)

DIY Cost: ₹800-₹1,800 (parts only)

You Save: ₹400-₹700 by doing it yourself!

Shop labor rates vary but typically run ₹800-₹1,500/hour. This repair takes a shop approximately 0.2-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.