🔧 Front Windshield Wiper Blades - Replacement

Replacing the front wiper blades on your Ram is a quick maintenance job that restores clear visibility in rain and road spray. The factory-style front arms use a simple hook connection, so the blades can be swapped without removing the wiper arms.

Difficulty Level: Beginner | Estimated Time: 0.5-1 hours

---

⚠️ Safety & Precautions

• Keep the wiper arms supported while the blades are off so they do not snap back onto the windshield.
• Turn the ignition off before starting. Do not use the wipers while your hands are near the arms.
• If the arms spring back, the metal arm can crack the windshield. Move them gently.
• No battery disconnect is required.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Gloves
• Safety glasses
• Soft cloth or towel

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Front wiper blade - Driver: 22", Passenger: 22" - Qty: 2

---

📋 Before You Begin

• Park on level ground with the parking brake set.
• Turn the ignition off and remove the key or keep the fob away from the vehicle.
• Lift one wiper arm at a time and place a towel on the windshield under the arm tip.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Lift the wiper arm

• Use your hand to gently lift the driver-side wiper arm away from the windshield.
• Place a soft cloth under the arm so it cannot hit the glass.
• Work one side at a time.

Step 2: Remove the old blade

• Find the small release tab where the blade connects to the hook end of the arm.
• Press the tab with your fingers and slide the blade downward to unhook it.
• If it is stuck, wiggle it gently while pulling it off the arm.

Step 3: Install the new blade

• Use the new 22" wiper blade and line up the hook opening with the arm.
• Slide the blade up into the hook until it clicks into place.
• Pull lightly on the blade to make sure it is locked.

Step 4: Repeat on the passenger side

• Use the same steps to remove the passenger-side blade.
• Install the second 22" wiper blade and confirm it is fully seated.

Step 5: Lower the arms and test

• Use both hands to lower each arm slowly back onto the windshield.
• Start the vehicle and run the washers once to confirm smooth operation.
• Make sure both blades sweep cleanly and do not chatter.

---

✅ After Repair

• Check that both blades sit flat on the glass.
• Run the washer fluid and inspect for streaks or missed spots.
• If one side skips, confirm the blade is fully locked onto the arm.

---

💰 DIY vs Shop Cost

Shop Cost: $60-$120 (parts + labor)

DIY Cost: $20-$50 (parts only)

You Save: $40-$70 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.5-1 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.