🔧 Highlander - Front Wiper Blade Replacement

You’ll be removing the old front wiper blade inserts/assemblies and snapping on new ones. Fresh blades improve visibility and reduce streaking, especially in rain and at night.

Difficulty Level: Beginner | Estimated Time: 0.25-0.5 hours

---

⚠️ Safety & Precautions

• ⚠️ Turn the ignition OFF and keep hands clear of the wiper arms.
• ⚠️ Do not let a bare wiper arm snap onto the windshield (it can crack the glass).
• ⚠️ Support the wiper arm with a towel on the glass while working.
• Battery disconnect is not required for this job.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Microfiber towel
• Work gloves
• Safety glasses
• Small flathead screwdriver

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Front wiper blades - Driver: 26", Passenger: 20" - Qty: 2

---

📋 Before You Begin

• Park on level ground and turn the ignition OFF.
• Lift each wiper arm carefully and place a microfiber towel on the windshield under the arm as a cushion.
• Confirm your new blades match the old ones in length and connector style before removing anything.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Lift and protect the wiper arm

• Lift the driver-side wiper arm away from the windshield with your hand (no tools).
• Place a microfiber towel on the glass under the arm.
• Keep one hand on the arm.

Step 2: Release the old wiper blade from the arm

• Rotate the blade so you can see the connector where the blade meets the metal arm (this is usually a “hook” style connection).
• Press the release tab on the connector with your thumb.
• If the tab is stuck, gently help it with a small flathead screwdriver (do not pry hard).
• Slide the blade down and off the hook.

Step 3: Install the new wiper blade

• Align the new blade connector with the hook on the arm (no tools).
• Slide it into place until you hear/feel a click.
• Gently tug the blade to confirm it’s locked on.

Step 4: Lower the arm safely

• Guide the wiper arm back down to the windshield slowly with your hand (no tools).
• Remove the microfiber towel.

Step 5: Repeat on the passenger side

• Repeat Steps 1–4 for the passenger-side blade (no tools, except the small flathead screwdriver if needed).
• Double-check the passenger blade length is 20" before installing.

---

✅ After Repair

• Start the vehicle and test the wipers on LOW, then HIGH.
• Spray washer fluid and confirm both blades wipe cleanly without skipping or banging.
• If there’s streaking, clean the windshield and blade rubber with a microfiber towel.

---

💰 DIY vs Shop Cost

Shop Cost: $40-$90 (parts + labor)

DIY Cost: $20-$60 (parts only)

You Save: $20-$30 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.4 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.