🔧 Yukon - Front Wiper Blade Replacement

Replacing the front wiper blades restores clear visibility in rain and reduces streaking and chatter. On your Yukon, the blades attach to the wiper arms with a common “J-hook” style connector that releases with a small tab.

Difficulty Level: Beginner | Estimated Time: 0.25-0.5 hours

---

⚠️ Safety & Precautions

• ⚠️ Keep hands clear of the hinge; the spring-loaded wiper arm can snap down.
• ⚠️ Put a towel on the windshield so the metal arm can’t chip the glass if it slips.
• ⚠️ Make sure the wipers are OFF and the ignition is OFF before lifting the arms.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Safety glasses
• Nitrile gloves
• Clean towel
• Step stool

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Front wiper blades - Driver: 22", Passenger: 22" - Qty: 2

---

📋 Before You Begin

• Park on level ground, shift to Park, and turn the ignition OFF.
• Confirm the wiper arms are in their “parked” (down) position before lifting them.
• Lay a clean towel on the lower windshield area as protection.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Lift the wiper arm

• Put on nitrile gloves and safety glasses.
• Use a step stool if needed to reach comfortably.
• Lift one wiper arm away from the windshield until it stays up on its own.
• Slide a clean towel under the arm on the glass. Prevents chips if it falls.

Step 2: Remove the old wiper blade (J-hook release)

• Rotate the blade so it sits roughly 90° to the wiper arm (makes the latch easier to access).
• Find the small release tab where the blade connects to the arm (at the “hook”).
• Press the tab with your thumb, then slide the blade downward toward the base of the arm to unhook it.
• Once it’s free, remove the blade completely.

Step 3: Install the new wiper blade

• Remove packaging from the new blade and verify size: 22".
• Line up the new blade’s connector with the wiper arm’s J-hook.
• Slide the blade into the hook until you hear/feel a solid “click.”
• Gently tug on the blade to confirm it’s locked in place. If it moves, re-seat it.

Step 4: Lower the wiper arm safely

• Hold the wiper arm firmly and remove the clean towel.
• Lower the arm slowly until the blade rests on the windshield.

Step 5: Repeat on the other side

• Repeat Steps 1–4 for the other front wiper blade (also 22").

---

✅ After Repair

• Start the vehicle and test wipers on LOW, HIGH, and WASH.
• Check that both blades wipe smoothly without skipping, streaking, or hitting the windshield trim.
• If there’s chatter, clean the windshield with glass cleaner and a microfiber towel.

---

💰 DIY vs Shop Cost

Shop Cost: $40-$90 (parts + labor)

DIY Cost: $25-$60 (parts only)

You Save: $15-$30 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.