🔧 Front Wiper Blade Replacement

Replacing the front wiper blades on your Silverado is a quick maintenance job that keeps visibility clear in rain and road spray. The blades use a simple hook-style attachment, so this is an easy no-special-tools repair.

Difficulty Level: Beginner | Estimated Time: 0.2-0.5 hours

---

⚠️ Safety & Precautions

• Turn the ignition off before lifting or moving the wiper arms.
• Carefully support each wiper arm so it does not snap back onto the windshield.
• Do not let the bare wiper arm rest on the glass.
• If the blades are frozen to the windshield, gently free them first so the arm does not bend.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Safety glasses
• Gloves
• Step stool or small ladder

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Front wiper blade, driver side 22" - Qty: 1
• Front wiper blade, passenger side 22" - Qty: 1

---

📋 Before You Begin

• Park on level ground and switch the ignition off.
• Set the parking brake.
• Lift one wiper arm at a time so it does not snap back.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Lift the driver-side wiper arm

• Use your hand to lift the driver-side wiper arm away from the windshield.
• Keep a firm grip on the arm so it does not spring back.
• Place a towel on the glass for protection.

Step 2: Remove the old driver-side blade

• Find the small release tab where the blade connects to the hook-shaped arm.
• Use your fingers to press the tab and slide the blade downward off the arm.
• Remove the blade completely and set it aside.

Step 3: Install the new driver-side blade

• Use the new 22" driver-side blade and align the hook with the blade connector.
• Slide the blade up onto the arm until it clicks into place.
• Gently tug the blade to make sure it is locked in.

Step 4: Repeat on the passenger side

• Lift the passenger-side wiper arm using your hand.
• Use your fingers to press the release tab and slide the old blade off.
• Install the new 22" passenger-side blade and make sure it clicks securely.

Step 5: Lower both wiper arms carefully

• Lower each arm back onto the windshield slowly.
• Do not drop the arm onto the glass.
• Make sure both blades sit flat against the windshield.

---

✅ After Repair

• Turn the wipers on and test both blades with washer fluid.
• Check that the blades sweep smoothly and do not chatter or skip.
• If one blade streaks, recheck that it is fully locked on the arm.

---

💰 DIY vs Shop Cost

Shop Cost: $50-$90 (parts + labor)

DIY Cost: $20-$40 (parts only)

You Save: $30-$50 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.