🔧 Expedition - Front Windshield Wiper Blade Replacement

Replacing the front wiper blades on your Expedition is a quick maintenance job that restores clear visibility in rain. You’ll remove the old blades from the wiper arms and click new blades on in their place.

Difficulty Level: Beginner | Estimated Time: 0.25-0.5 hours

---

⚠️ Safety & Precautions

• ⚠️ Turn ignition OFF and keep hands clear of the wiper linkage.
• ⚠️ Put a towel on the windshield so the bare wiper arm can’t snap down and crack the glass.
• ⚠️ Do not force the wiper arm past its normal lift range.
• Battery disconnect is not required.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Microfiber towel
• Small flathead screwdriver
• Measuring tape
• Nitrile gloves
• Safety glasses

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Front wiper blades - Replace in pairs - Qty: 2

---

📋 Before You Begin

• Park on level ground and turn the ignition OFF.
• Lift each front wiper arm up away from the glass until it stays up on its own.
• Place a microfiber towel on the windshield under each wiper arm.
• If unsure on size, measure the blade length first.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Measure the wiper blades

• Use a measuring tape to measure the rubber wiping edge end-to-end on the driver blade.
• Use the measuring tape to measure the passenger blade.
• Buy matching lengths and the correct attachment style for your Expedition.

Step 2: Position the wiper arm

• Lift the driver-side wiper arm away from the windshield.
• Keep the microfiber towel under the arm to protect the glass.

Step 3: Release the old blade from the wiper arm

• Find the small release tab/clip where the blade connects to the arm (usually a “J-hook” style hook connection).
• If the tab is stiff, use a small flathead screwdriver to gently press the release tab. (A flathead screwdriver is a small, straight-tip screwdriver used to pry or press clips.)
• Slide the blade down toward the base of the arm to unhook it, then remove the blade.

Step 4: Install the new blade

• Align the new blade’s connector with the wiper arm hook/connector.
• Push the blade into place until you hear/feel it click and it can’t slide back off.
• Gently tug the blade with your hand to confirm it’s locked.

Step 5: Lower the wiper arm carefully

• Remove the microfiber towel.
• Lower the wiper arm back onto the windshield slowly, by hand.

Step 6: Repeat on the passenger side

• Repeat Steps 2–5 for the passenger-side blade.
• Replace both blades together for even wiping.

---

✅ After Repair

• Turn ignition ON and run the front wipers on low speed with washer fluid.
• Confirm there’s no streaking, chattering, or the blade coming loose.
• If the blade chatters, clean the windshield and rubber edge with a damp microfiber towel.

---

💰 DIY vs Shop Cost

Shop Cost: $40-$90 (parts + labor)

DIY Cost: $25-$60 (parts only)

You Save: $15-$30 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.4 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.