🔧 Front Windshield Wiper Blades - Replacement

Replacing the front wiper blades on your F-150 is quick and easy. Fresh blades restore clear visibility in rain and help prevent streaking, skipping, and noise.

Difficulty Level: Beginner | Estimated Time: 0.2-0.5 hours

---

⚠️ Safety & Precautions

• Turn the ignition off before lifting the wiper arms.
• Keep the wiper arm under control; it can snap back and crack the windshield.
• Do not let the bare metal arm rest on the glass.
• If the blades are stuck in ice or dirt, do not force them.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Safety glasses
• Microfiber towel

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Front wiper blades - Driver: 22", Passenger: 22" - Qty: 2

---

📋 Before You Begin

• Park on level ground and set the parking brake.
• Turn the ignition off and make sure the wipers are in the parked position.
• Place a microfiber towel on the windshield edge if you want extra protection.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Lift the wiper arm

• Carefully lift the driver-side wiper arm away from the windshield.
• Do the same for the passenger-side arm.
• Hold the arm firmly the whole time.

Step 2: Remove the old blade

• At the blade connection, press the release tab by hand.
• Slide the old blade downward and off the wiper arm.
• If it is tight, gently wiggle it while pulling it free.

Step 3: Install the new blade

• Align the new blade with the wiper arm hook.
• Slide it into place until you hear or feel a click.
• Pull lightly on the blade to make sure it is locked in.

Step 4: Repeat on the other side

• Replace the second blade the same way.
• Make sure both blades are fully seated and facing the correct direction.

Step 5: Lower the arms and test

• Carefully lower both wiper arms back onto the windshield.
• Turn the ignition on and run the washers for one cycle.
• Check for smooth movement, proper contact, and no streaking.

---

✅ After Repair

• Test the wipers on washer fluid and normal wipe mode.
• Listen for chatter, skipping, or lifting at highway speed.
• Recheck that both blades are fully latched if one seems loose.

---

💰 DIY vs Shop Cost

Shop Cost: $60-$120 (parts + labor)

DIY Cost: $25-$50 (parts only)

You Save: $35-$70 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.