🔧 Camry - Front Turn Signal Bulb Replacement

You’ll replace the front turn signal bulb by accessing the back of the headlight housing from under the hood. The bulb sits in a twist-lock socket; once you remove the socket, the bulb pulls straight out.

Difficulty Level: Beginner | Estimated Time: 0.3-0.8 hours

---

⚠️ Safety & Precautions

• ⚠️ Turn the lights OFF and remove the key before starting.
• ⚠️ Let the headlight area cool if it was recently on.
• ⚠️ Wear gloves; avoid touching the glass part of the new bulb.
• ⚠️ Do not force the socket—plastic tabs can crack.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Safety glasses
• Nitrile gloves
• Flashlight
• Trim clip tool (specialty)
• 10mm socket
• 1/4" ratchet

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Front turn signal bulb (7440A amber) - Qty: 2

---

📋 Before You Begin

• Park on level ground and set the parking brake.
• Open the hood and use a flashlight so you can see behind the headlight.
• Replace both sides for matching brightness.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Confirm which bulb you’re changing

• Turn the hazards ON briefly, walk to the front, and confirm which side is out.
• Turn hazards OFF again before working under the hood.

Step 2: Access the back of the headlight housing

• Open the hood and locate the rear of the headlight on the side you’re replacing.
• If your hand space is tight, remove the air intake snorkel clips/bolt near the headlight using a trim clip tool (specialty) and 10mm socket with a 1/4" ratchet.
• A flashlight helps you find the correct socket.

Step 3: Remove the turn signal bulb socket

• Find the turn signal socket at the back of the headlight (it will have two wires leading to it).
• Grip the socket and rotate it counterclockwise about 1/4 turn by hand, then pull it straight out.

Step 4: Remove the old bulb from the socket

• Hold the socket firmly and pull the bulb straight out (it’s a friction-fit).
• Use nitrile gloves to keep skin oils off the new bulb.

Step 5: Install the new bulb

• Push the new 7440A amber bulb straight into the socket until fully seated.
• Do not twist the bulb—this style presses in.

Step 6: Reinstall the socket

• Insert the socket into the headlight housing, making sure it sits flush.
• Rotate clockwise about 1/4 turn until it locks.

Step 7: Reinstall any parts you moved for access

• If you removed the intake snorkel/clips, reinstall them using the 10mm socket, 1/4" ratchet, and trim clip tool (specialty).

---

✅ After Repair

• Turn hazards ON and confirm the new front turn signal flashes normally on both sides.
• If it still doesn’t work, re-check that the bulb is fully seated in the socket and the socket is fully locked.
• Verify the turn signal indicator on the dash flashes at a normal speed (fast flashing usually means a bulb still isn’t working).

---

💰 DIY vs Shop Cost

Shop Cost: $40-$120 (parts + labor)

DIY Cost: $6-$30 (parts only)

You Save: $34-$90 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.3-0.7 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.