🔧 Camry - Front Turn Signal Bulb Replacement

Your front turn signal bulb sits inside the headlight housing. Replacing it usually takes just a few minutes per side and restores proper signaling (and avoids tickets or unsafe driving).

Difficulty Level: Beginner | Estimated Time: 0.3-0.7 hours

---

⚠️ Safety & Precautions

• ⚠️ Turn the lights OFF and remove the key before starting.
• ⚠️ Let the headlight area cool for 10-15 minutes if recently on.
• ⚠️ Don’t touch the new bulb’s glass with bare fingers; skin oils can shorten bulb life.
• ⚠️ Wear safety glasses—tight spaces can pop clips loose.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Nitrile gloves
• Safety glasses
• Flashlight
• Small flat trim tool

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Front turn signal bulb (7440A amber) - Replace in pairs - Qty: 2

---

📋 Before You Begin

• 🅿️ Park on level ground and set the parking brake.
• 💡 Turn the headlight/turn signal switch to OFF.
• 🔦 Have a flashlight ready so you can see behind the headlight.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Find the turn signal bulb socket

• Open the hood.
• Use a flashlight to look behind the headlight assembly on the side you’re replacing.
• Locate the turn signal socket (it’s a twist-lock socket going into the headlight housing).

Step 2: Remove the bulb socket

• Put on nitrile gloves and safety glasses.
• Grip the socket and rotate it about 1/4 turn counterclockwise by hand, then pull it straight out.
• If it’s stuck, use a small flat trim tool gently to help you start the rotation. Don’t pry on the plastic lens.

Step 3: Remove the old bulb

• Pull the old bulb straight out of the socket (it’s a push-in style).

Step 4: Install the new bulb

• With nitrile gloves on, push the new 7440A amber bulb straight into the socket until fully seated.
• If you accidentally touch the glass, wipe it clean and dry before installing.

Step 5: Reinstall the socket

• Insert the socket back into the headlight housing.
• Twist clockwise about 1/4 turn until it locks in place.

Step 6: Repeat on the other side

• Replace the other front turn signal bulb the same way. Pairs help match brightness and color.

---

✅ After Repair

• ✅ Turn the key to ON and test left and right turn signals.
• ✅ Verify the turn signal flashes at a normal speed (fast flashing usually means a bulb isn’t working or isn’t seated).
• ✅ Walk around the Camry and confirm the front signal is amber and bright.

---

💰 DIY vs Shop Cost

Shop Cost: $50-$120 (parts + labor)

DIY Cost: $6-$20 (parts only)

You Save: $30-$110 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.3-0.7 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.