🔧 Headlight Bulbs - Bulb Replacement

Assuming your Rogue has serviceable halogen headlight bulbs. On some SL headlight setups, the low beams are factory LED and are not replaceable as a bulb; in that case the whole headlamp assembly or LED module must be serviced. If your lights are halogen, this job is straightforward and can usually be done from the engine bay.

Difficulty Level: Beginner | Estimated Time: 0.5-1 hour

---

⚠️ Safety & Precautions

• Let the headlights cool fully before touching them.
• Do not touch the glass on halogen bulbs with bare fingers; skin oils can shorten bulb life.
• Turn the lighting switch off before starting.
• If your Rogue has factory LED low beams, do not try to pry the LED module apart.
• Disconnecting the battery is not usually required for bulb replacement.

---

🔧 Required Tools

You'll need the following tools for this repair:

• 10mm socket
• 1/4-inch ratchet
• 1/4-inch extension
• Flat blade trim tool
• Nitrile gloves
• Safety glasses

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Headlight bulb set - Qty: 2

---

📋 Before You Begin

• Park on level ground and set the parking brake.
• Turn the ignition off and remove the key or keep the fob away from the vehicle.
• Open the hood and make sure the headlamp area is cool.
• Keep the new bulbs in their packaging until install.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Access the back of the headlamp

• Open the hood.
• Use the 10mm socket and 1/4-inch ratchet to remove any intake duct or splash shield fasteners blocking access to the rear of the headlamp, if equipped.
• Set the fasteners aside in order so they go back in the same spots.

Step 2: Remove the old bulb

• Reach behind the headlamp and unplug the electrical connector from the bulb.
• Twist the bulb holder counterclockwise by hand and pull it straight out.
• If there is a locking tab, press it gently with a flat blade trim tool and release the connector.
• Do not force the bulb.

Step 3: Install the new bulb

• Put on nitrile gloves before handling the new bulb.
• Install the new bulb into the housing in the same position as the old one.
• Twist it clockwise by hand until it seats fully.
• Reconnect the electrical connector until it clicks.

Step 4: Reassemble the access area

• Reinstall any removed ducting or covers with the 10mm socket and 1/4-inch ratchet.
• Make sure nothing is left loose near the belt drive or fan area.

Step 5: Test both lights

• Turn the headlights on and confirm both new bulbs illuminate.
• Check low beam, high beam, and parking light operation if you disturbed the front lamp area.
• If one side does not work, recheck the connector and bulb seating.

---

✅ After Repair

• Park facing a wall and confirm both beams are aimed evenly.
• If the light output is dim or uneven, verify the bulb is fully seated.
• Keep the old bulbs only if they are not burned or damaged; otherwise replace both as a pair.

---

💰 DIY vs Shop Cost

Shop Cost: $120-$260 (parts + labor)

DIY Cost: $30-$80 (parts only)

You Save: $90-$180 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.5-1 hour.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.