🔧 Durango - Headlight Bulb Replacement

On your Durango, the exact replacement process depends on which headlight system you have (halogen vs HID/LED) and which bulbs you mean (low beam, high beam, or turn/parking). Some SRT headlamps use LED modules that are not simple “bulb swaps” and require replacing the module or housing.

Answer the two questions below and I’ll give you the exact step-by-step procedure and correct bulb types.

Difficulty Level: Intermediate | Estimated Time: 0.5-2.0 hours

---

⚠️ Safety & Precautions

• ⚠️ Turn lights OFF and let the headlamp cool before touching anything.
• ⚠️ If equipped with HID (xenon), the igniter can produce high voltage—do not power the lights while disconnected.
• ⚠️ Do not touch glass bulbs with bare fingers; skin oils shorten bulb life.
• ⚠️ Support the hood securely and keep tools clear of the battery positive terminal.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Nitrile gloves
• Safety glasses
• Flashlight

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Headlight bulb(s) or LED module (vehicle-specific) - Qty: 2

---

📋 Before You Begin

• 🧭 Park on level ground, set the parking brake, and switch the headlamps to OFF.
• Open the hood and identify the rear of the headlamp assembly on the side you’re starting with.
• Two quick questions so I give you the exact procedure:
  • Which are you replacing: low beam, high beam, or both?
  • On the back of the headlamp, do you see a removable round dust cap you can twist off, or does it look like a mostly sealed housing with a large module/heat sink?

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Identify the headlamp type

• Use a flashlight to look behind the headlamp for a twist-off dust cap (typical serviceable bulb access) or a large sealed module/heat sink (often LED).
• Reply with what you see for exact steps.

Step 2: I’ll provide the exact replacement steps

• Once you confirm low/high beam and what the rear cover looks like, I’ll lay out the correct removal method, bulb/module type, and reassembly checks.

---

✅ After Repair

• 🔎 Verify both sides match in color and brightness.
• Check high/low beam function and ensure no warning messages appear on the dash.
• If the beam pattern looks off after work, the headlamp may need aiming.

---

💰 DIY vs Shop Cost

Shop Cost: $150-$600 (parts + labor, depends on bulb vs LED module)

DIY Cost: $30-$400 (parts only, depends on bulb vs LED module)

You Save: $120-$200+ by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.5-1.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.