🔧 MAF Sensor - Replacement

The mass air flow sensor tells the engine computer how much air is entering the engine. If it fails or gets contaminated, your Crosstour may run rough, hesitate, or set a check engine light. Replacing it is a simple job on your Crosstour and usually takes less than an hour.

Difficulty Level: Beginner | Estimated Time: 0.5-1 hour

---

⚠️ Safety & Precautions

• Let the engine cool down before working near the air intake.
• Turn the ignition off and remove the key before unplugging the sensor.
• Do not touch the new sensor element with your fingers.
• Do not use brake cleaner or carb cleaner on the new sensor.
• Battery disconnect is not required for this repair.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Phillips screwdriver
• 8mm socket
• Ratchet
• Small torque wrench
• Trim tool
• Safety glasses
• Gloves

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Mass air flow sensor - Qty: 1
• Throttle body/intake tube gasket - Qty: 1, if damaged or removed

---

📋 Before You Begin

• Park on level ground and set the parking brake.
• Turn the ignition off and make sure the engine is cool.
• Open the hood and locate the air intake tube between the air box and throttle body.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Remove the intake duct

• Use an 8mm socket and ratchet to loosen the intake duct clamps.
• If needed, use a Phillips screwdriver to remove any resonator or snorkel fasteners.
• Lift the duct out enough to reach the sensor connector.
• Work gently to avoid cracking the plastic.

Step 2: Unplug the MAF sensor

• Press the connector tab and unplug the sensor harness by hand.
• Inspect the connector for corrosion or bent pins.

Step 3: Remove the sensor

• Use a Phillips screwdriver to remove the MAF sensor screws.
• Lift the old sensor straight out of the housing.
• Torque note: the new sensor screws should be tightened to 2 N·m (18 in-lbs).

Step 4: Install the new sensor

• Place the new sensor in the same direction as the old one.
• Install the screws by hand first, then tighten with the Phillips screwdriver.
• Do not overtighten the screws.

Step 5: Reinstall the intake duct

• Reinstall the duct and make sure it seats fully on both ends.
• Use the 8mm socket to tighten the clamps.
• Torque note: snug the clamps to 3-5 N·m (27-44 in-lbs).

Step 6: Reconnect and verify

• Reconnect the sensor harness until it clicks.
• Make sure no hoses or connectors are left loose.
• Close the hood.

---

✅ After Repair

• Start the engine and let it idle for a minute.
• Check for a smooth idle and normal throttle response.
• If the check engine light was on, clear codes with a scan tool if needed.
• Take a short test drive and confirm the light does not return.

---

💰 DIY vs Shop Cost

Shop Cost: $180-$350 (parts + labor)

DIY Cost: $50-$160 (parts only)

You Save: $130-$190 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.5-1 hour.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.