🔧 Crosstour - Engine Air Filter Replacement

The engine air filter keeps dirt and debris out of the intake system. Replacing it helps maintain airflow, fuel economy, and engine performance. This is a simple maintenance item and a good first DIY job.

Difficulty Level: Beginner | Estimated Time: 0.2-0.5 hours

---

⚠️ Safety & Precautions

• Turn the engine off and let it cool before opening the air box.
• Keep loose dirt out of the air intake opening.
• Do not drive with the air box lid unsecured.
• No battery disconnect is required for this repair.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Phillips screwdriver
• Flat-blade screwdriver
• Gloves
• Safety glasses

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Engine air filter - Qty: 1

---

📋 Before You Begin

• Park on level ground and set the parking brake.
• Make sure the engine is off and cool.
• Open the hood and secure it fully.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Open the air filter housing

• Locate the air filter box in the engine bay.
• Use a Phillips screwdriver to loosen the air box cover screws or clamps.
• If your cover uses clips, use a flat-blade screwdriver to gently release them.
• Do not force the cover.

Step 2: Remove the old air filter

• Lift the air box cover carefully.
• Use your gloves to remove the old filter.
• Check the housing for leaves, dirt, or debris.
• If needed, wipe the inside of the box clean with a dry cloth.

Step 3: Install the new air filter

• Place the new engine air filter into the housing the same way the old one came out.
• Make sure the filter sits flat all the way around.
• Seal all edges before closing.

Step 4: Reinstall the air box cover

• Set the cover back on the housing.
• Use the Phillips screwdriver to tighten the screws or secure the clamps.
• Make sure the cover is fully seated and latched.
• Do not overtighten the screws.

---

✅ After Repair

• Start the engine and listen for any unusual intake noises.
• Check that the air box is closed evenly on all sides.
• Make sure no tools or rags were left in the engine bay.

---

💰 DIY vs Shop Cost

Shop Cost: $60-$120 (parts + labor)

DIY Cost: $20-$35 (parts only)

You Save: $40-$85 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.