🔧 Crosstour - Cabin Air Filter Replacement

Your Crosstour’s cabin air filter cleans the air coming through the HVAC vents (A/C and heater). Replacing it helps airflow, reduces musty smells, and keeps dust/pollen out of the cabin.

Difficulty Level: Beginner | Estimated Time: 0.25-0.5 hours

---

⚠️ Safety & Precautions

• ⚠️ Turn the ignition OFF and remove the key before starting.
• ⚠️ Don’t force plastic tabs—if it doesn’t move, re-check the latch points.
• ⚠️ Battery disconnect is not required for this job.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Phillips #2 screwdriver
• Plastic trim removal tool
• Flashlight
• Nitrile gloves
• Safety glasses

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Cabin air filter - Qty: 1

---

📋 Before You Begin

• Park on level ground and set the parking brake.
• Move the passenger seat back to give yourself room.
• Empty the glove box so nothing falls out.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Open and release the glove box

• Open the glove box fully and support it with your hand.
• On the right side, disconnect the glove box “damper” (the small arm that slows the glove box). Use a plastic trim removal tool to gently pry it off the pin if needed. A damper is a small limiter that prevents the glove box from dropping fast.

Step 2: Drop the glove box down

• Push inward on both glove box side walls to clear the rubber stops. Use your hands (no tools needed) and let the glove box swing downward.
• Tip: Push one side at a time if tight.

Step 3: Remove the cabin filter door

• Behind the glove box, locate the rectangular cabin filter housing.
• Press the tabs on the housing cover and pull it straight off. Use a flashlight to see the tabs clearly.

Step 4: Remove the old filter

• Slide the filter tray/filter out toward you with your hands.
• Keep it level to avoid dumping leaves and dust into the blower area.

Step 5: Install the new filter

• Check the airflow arrow on the new filter and match it to the housing’s airflow direction marking.
• Slide the new filter in fully and evenly by hand (don’t crush the pleats).

Step 6: Reassemble the glove box

• Reinstall the cabin filter housing cover by hand until both tabs click.
• Lift the glove box back up, then push the sides inward again to get the stops back past the dash opening.
• Reconnect the glove box damper arm on the right side by pushing it back onto the pin by hand (use the plastic trim removal tool only if needed to align it).

---

✅ After Repair

• Start the engine and run the fan on medium to confirm strong airflow and no rattles.
• Switch between fresh air and recirculate to ensure the airflow sounds normal.
• If you notice a whistling noise, re-check that the filter is fully seated and the cover is snapped in.

---

💰 DIY vs Shop Cost

Shop Cost: $80-$160 (parts + labor)

DIY Cost: $15-$40 (parts only)

You Save: $40-$140 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.3-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.