🔧 Civic - Front Wiper Blade Replacement

Replacing the front wiper blades restores clear visibility and prevents streaking or skipping in rain. On your Civic, this is a quick job: lift the wiper arms, release the blade from the arm, and snap the new blades on securely.

Difficulty Level: Beginner | Estimated Time: 0.25-0.5 hours

---

⚠️ Safety & Precautions

• ⚠️ Turn the ignition OFF and remove the key/fob from the car before lifting wiper arms.
• ⚠️ Do not let a bare wiper arm snap onto the windshield—put a towel on the glass to protect it.
• ⚠️ Lift the wiper arm gently; don’t force it past its normal hinge range.
• ⚠️ Battery disconnect is not required.

---

🔧 Required Tools

You'll need the following tools for this repair:

• Microfiber towel
• Safety glasses
• Nitrile gloves

---

🔩 Required Parts

HowToo sells all the parts you need for this repair:

• Front wiper blades - Driver: 26", Passenger: 18" - Qty: 2

---

📋 Before You Begin

• Park your Civic on level ground and switch the ignition OFF.
• Place a microfiber towel on the windshield under each wiper arm area in case the arm slips.
• Cold rubber can chatter; warm blades work better.

---

🔨 Step-by-Step Instructions

Follow these steps in order:

Step 1: Lift the wiper arms

• Use your hands (gloves recommended) to lift the driver-side wiper arm away from the windshield until it stays up.
• Lay a microfiber towel on the windshield below the arm.

Step 2: Release the old blade from the wiper arm

• Hold the wiper arm with one hand so it can’t spring down.
• With your other hand, rotate the wiper blade so you can see the connector where it attaches to the arm.
• Press the small release tab on the connector, then slide the blade down and off the arm hook.
• If stuck, wiggle while pressing the tab.

Step 3: Install the new blade

• Remove the new blade from packaging and confirm it matches the side (driver vs passenger) by length.
• Slide the new blade connector onto the wiper arm hook until it clicks.
• Gently tug the blade to confirm it’s locked in place.

Step 4: Lower the wiper arm carefully

• Use your hand to guide the wiper arm back down onto the windshield slowly.
• Remove the microfiber towel.

Step 5: Repeat for the passenger side

• Repeat Steps 1–4 for the passenger-side wiper blade.

---

✅ After Repair

• Start the car and test wipers on LOW, then HIGH, and use washer fluid to confirm smooth wiping.
• If you see streaking, clean the windshield with glass cleaner and a microfiber towel.
• Make sure both blades park correctly at the bottom of the windshield.

---

💰 DIY vs Shop Cost

Shop Cost: $50-$120 (parts + labor)

DIY Cost: $25-$60 (parts only)

You Save: $25-$60 by doing it yourself!

Shop labor rates vary but typically run $100-$150/hour. This repair takes a shop approximately 0.2-0.5 hours.

---

🎯 Ready to get started?

HowToo makes it easy: same-day/2-day shipping on every part, plus all the tools and specialty tools you need! Check out the parts and tools sections below to add everything to your cart.